ILDA DB25F DRIVER

Please use the soft cloth to clean the surface of product. Disconnect input power before maintain. Before connect or disconnect the power, please adjust the luminance of the laser diode to the least to avoid any damage to the laser diode. Signal inputs shall be designed to accept this voltage without any damaging results. A differential voltage level of 0V shall produce no red output.

Uploader: Jurr
Date Added: 18 September 2009
File Size: 5.42 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 7972
Price: Free* [*Free Regsitration Required]

LazeriĊ³ valdymo programa “I Show”

The address code of first light usually by 1, the second light is 14 and so on. Y Controls the vertical beam position. Shutter Optical shutter intended to extinguish all light from the graphics scanners.

A differential voltage level of 0V shall produce no green output. A differential voltage level of 0V shall produce no blue output.

Signal outputs shall be current limited so that if they are shorted to ground, damage will not result. It is important to note that this portion of the ISP-DB25 is a projector interlock which may be separate from the remote interlock connector on a laser used with the projector.

Red nm to nm Green nm to nm Blue nm to nm Deep Blue supplied on user1 nm to nm Yellow supplied on user2 nm to nm. In case of safety, it’s very important that to connect the earth ikda line. Set the light immobility and try to avoid strong shake or hit. Power must be disconnected before maintenance or repair.

  BAN GHOST SP3 TU NHAN DRIVER

A voltage level of 0 volts shall close the shutter so that no light is emitted from the graphics scanners. However, this signal can be used for any projector db2f information as long as the maximum voltage ranges are observed.

Please check the voltage whether is the same with the one showed on the equipment or not. R Controls the red intensity.

Laser Light ILDA ishow software DMX laser light Projector/Stage laser lighting laser show software

Controls the blue intensity. Required Signals The required signals are those which would typically be present on tape playback systems and laser graphics computer systems.

When the 10th code is OFF, code are function codes. These are intended to keep the projector from outputting light if inadvertently connected to non-laser signal sources such as SCSI, Parallel or serial connectors.

Shogun 3D+RGB

Here’s how this is done: Signal input connection port of the laser perform software that in accordance with the ILDA standard. It must ask for the technical person and set eb25f light safety when installation. Before connect or disconnect the power, please adjust the luminance of the laser diode to the least to avoid any damage to the db52f diode. It provides a logical ordering of signals to facilitate easy recollection in the field without a diagram.

  GATEWAY NV40 XP DRIVER

Return signal from the projector. For stereoscopic applications where it is desired to have a separate signal for a second X scanner, this shall be supplied on the “User-defined signal 4” pair. If the 10th code is OFF, the codes are function code.

Driver for Laserworld Showeditor USB interfaces

The DB connector connects laser graphics signal sources to laser graphics projectors. Don’t seperate laser machine from laser power and repaire them by yourself otherwise no good repair service will be supplied. Operate it accord the user manual. The following recommendations are provided for these applications to ensure maximum compatibility between projector manufacturers. Where it is desired to have a separate signal which controls the yellow intensity, this shall be supplied on the “User-defined signal 2” pair.

We provide this information as a service to laserists using the Backstage area. This is a unipolar analogue signal whose voltage range is 5V peak-to-peak differential.

The Colour Channel Usage chart below shows the wavelengths to be used for 3- 4- 5- and 6-channel colour systems.